Follow the steps below to get your Aero Ranger EdgeAI module up and running.
Included accessories
Please check you have received the following items:
1x Aero Ranger edgeAI device
1x 4G & WiFi antenna (2x SMA connectors)
1x GPS antenna (SMA connector)
1x Cigarette lighter power cable
1x Wall adapter power supply (if applicable)
Connect your accessories
Cameras
Two (2) Power over Ethernet (PoE) cameras can be plugged Ethernet Port 1 and Port 2 of the device. Do not connect more than two (2) cameras.
Refer to the FAQ section below for more detail about the camera input ports.
Antenna
Connect all antennae before turning the device on.
4G/LTE: There is one (1) SMA connector for the 4G/LTE.
WiFi: There is one (1) RP-SMA connector for the Wi-Fi hotspot functionality
GPS: There is one (1) SMA connector for the GPS
Power
The EdgeAI module should be powered from a 12V power source capable of supplying 5 amps. Most modern vehicle cigarette lighter sockets should be able to supply enough power to the edgeAI module.
Alternatively, you can use the included 240volt to a 12-volt transformer.
To turn on the device, connect power and the device will automatically boot up.
WiFi
When the device turns on, the WiFi router of the edgeAI module will create a network which you can join on your iOS device. It may take 60 to 90 seconds for the WiFi network to appear after turning on the device. The WiFi credentials are listed on the bottom of the edgeAI module. It may be a good idea to take a photograph of the credentials as once the device is installed, you may not be able to see the sticker on the bottom.